...
Note that, by default, in the 3D Scene view Show All Clips is selected:
This is necessary to enable you to view data from the backup clip, which contains the data before occlusion fixing, as well as the current (occlusion-fixed) clip.
...
If circles are displayed for some markers during some time ranges, it indicates that the marker position was changed by more than 1 cm by occlusion fixing.
In this case, check the position of the occlusion-fixed marker. If it doesn’t look right, the cause is likely to be either a labeling mistake or an occlusion-fixing error. To fix these problems, see Correcting labeling mistakes.
| Scroll pagebreak |
|---|
| Anchor | ||||
|---|---|---|---|---|
|
If you notice any swaps, mis-labels or other issues with marker data and the file has already been occlusion fixed, the recommended workflow is to restore the data back to its original state before it was occlusion-fixed.
...
- From the Current Subject chooser, select the required subject, or if you want to work on everything, select All.
In the Restore section of the Marker Editing panel, with selected subject active, select Restore All Data.
- Fix any labeling issues that are present in your data. For more information, see Use the Labeling panel in Clean up data and Fix common labeling issues.
- Re-run occlusion fixing from the Processing panel.
- Re-run Solve Solving to update the solving skeletons.