...
For instructions on setting up Vicon Vero systems, see the PDF Vicon Vero Quick Start Guide, which you can download from the Vicon website.
Vero camera status LEDs
Location: Camera's Properties pane > Settings section
...
| Info |
|---|
Note
In certain camera modes and in certain system configurations, the status LEDs on the camera are automatically turned off to ensure maximum power is available to the strobe. |
Vero Tap to Select camera feature
...
You can remove a camera’s Bumped status in Tracker. If this is a frequent occurrence, you can change its sensitivity to being tapped by reducing the Bump Detection Sensitivity. For more information, see the following section.
Vero bump detection and display
...
To clear a camera's Bumped status:
For a single camera:
- In the System Resources list, select the bumped camera.
- In the Properties pane, go to the Status section and clear the Bumped check box.
...
- Bump detection is active only on calibrated cameras.
- Bump detection cannot detect movement that does not change the local gravity vector, for example. slow translation with no rotation; rotation about the G-vector.
- Bump detection cannot detect movements that occur when the camera is not connected to a live system.
- The camera is detected as bumped when the reading from the accelerometer is sufficiently different from the last reading. Therefore gradual changes (for example, a slipping camera mount) may not be detected until they are large enough to trigger a new notification.
Vero temperature sensor display
...
