Cables are supplied with Vicon Valkyrie systems to connect Valkyrie hardware components. Most of these are network cables, which carry the power, all the communication data, and synchronization.

Important
Where Ethernet cable is required to connect cameras, we recommend using Vicon-supplied cable.
For details of the cables supplied with your Vicon Valkyrie system, see the bill of materials accompanying your product shipment. If any cables are missing on receipt, or if you require additional cables later, please contact Vicon or your nearest agent or distributor.

Note the following cable requirements for Valkyrie systems. For more information about any of the components, contact Vicon Support.

Valkyrie cameras are connected to an Ethernet switch (usually PoE++), with cables of a minimum type of Category 6 (Cat 6).
- Vicon-supplied Ethernet cable for Valkyrie cameras are equipped with an IP65 cable cap and seal, which, when correctly fitted to each camera, ensure that the connection is IP65-rated.
- If you use Cat 6 Ethernet cable that is not supplied by Vicon, to achieve IP65 protection for your Valkyrie cameras, you must fit an IP65 cable cap and seal (obtained from Vicon) to the cable and correctly fit the cable to the Ethernet port on the camera.
  For instructions, see Add IP65 protection to Ethernet cable and Remove and replace IP65 cable cap in the Vicon Valkyrie Quick Start Guide.
  Important: Cat 6 cables must only be UK/EU (LSOH or LSZH) or US (Premium or CMP).
Other Vicon network cables with RJ45 connectors (eg, Lock to switch) are Cat 6 (minimum) cable type, without an IP65 cable cap.

Caution: To ensure Valkyrie cameras remain IP65-rated, if you remove the IP65 cable cap that protects the connection between the Ethernet cable and the camera, always replace it correctly. For instructions, see Remove and replace IP65 cable cap in the Vicon Valkyrie Quick Start Guide.

Loading

The following additional cables and accessories may also be supplied, depending on your system topology:

System component	Cables required
SFP+ switch	Direct Attach Cables and, if required, SFP+-to-Ethernet transceivers For information about transceivers, see SFP+ transceivers for Valkyrie systems on the Vicon documentation website.
Connections between SFP+ ports	10 Gb SPF+ Direct Attach Cables
Connections between SFP+ and RJ45 Ethernet ports	SFP+ to Ethernet transceivers Note that a Lock power switch must be connected via an SFP-10G-T-PLU transceiver
Supported FLIR cameras	Vicon sync cable (to connect a Lock to the FLIR camera) and FLIR 5 m USB 3.1 locking cable (to connect the camera to the PC)
Vicon Lock Lab	Eight Weidmüller connectors to connect the Lock to third-party analog capture devices
Two Lock units	Lock-to-Lock Link cable

Depending on your Valkyrie system components, you may also require commercially available cables to connect a Lock to third-party devices.

Such cables may be:

Created by you:
- To connect the provided Weidmüller connectors to the analog source connector
- For remote triggering devices
Obtained from video specialist distributors (such as for timecode, video devices such as broadcast and VESA Stereo video)

Important
Ethernet cables for use in Vicon Valkyrie systems must be of a minimum type of Category 6 (Cat 6) with an insulation rating of either:

UK/EU: LSOH- or LSZH-rated
US: Plenum- or CMP-rated

Browser not supported