Test the retarget setup

You can test the retarget setup in Shogun Post or in Shogun Live.

To test the retarget setup in Post:

1. When you have finished setup, ensure you have selected Map Mode again to turn it off (the Map Mode button is not green).

   You are returned to the motion in the file, ideally a ROM.

2. In the toolbar at the top of the Subject Setup panel, click the Retarget skeleton(s) over current frame button.

   Open

   

3. If the skeleton looks good, select the Retarget over frame range button (or select a range and use the Retarget skeleton(s) over selected range button).

   After retargeting has finished, scrub the time bar to check that the motion and positioning of the retargeted skeleton now matches that of the target skeleton over the whole range (or selected range).

To test the retarget setup in Live:

1. Load the VSR. To do this, in the Tracking panel, ensure the subject is selected and click the Properties tab.

2. Click the Retarget field to display the files found in your Retargets folder, and select the retarget from the list.

3. In the Processing panel, in the General section, ensure that the Processing Output Level is set to Retarget.

   Your FBX is displayed and is driven by the source skeleton. The retarget skeleton is recorded as part of the MCP capture.