Versions Compared

Version Old Version 21 New Version Current
Changes made by

Gisela Roberts

Gisela Roberts

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

To troubleshoot issues with Vicon IR lights, complete the following steps checks in the order shown.

Note

Important
Ensure all tests are undertaken by a qualified, trained engineertrainedengineer. Ensure safe working practices are followed at all times

...

Scroll only

...

2

...

2

...

square

Initial checks

  • Check the indicator is green, showing that the unit is receiving power.
  • Ensure Ensure equipment is suitably rated for the Vicon IR lightlight.

Scroll pagebreak

Check illuminating (IR) LEDs

  • Check the IR LEDs are working. (It is sometimes difficult to see infrared lights working in high brightness conditions) .

Check status indicator LED

  • Check the status indicator LED (located at the base of the Vicon IR light) to determine the status of the lightlight . The status indicator LED turns green when power is supplied to the Vicon IR lightlight.

Final checks

  • Check that the Vicon IR lightlight is aligned correctly.
  • Check that the protective film has been removed.

Contact Vicon

If the previous checks did not solve your issue:

  1. Note the serial number (found on the label at the top of your Vicon IR light).
  2. Contact Vicon Support .

  For more information about Vicon IR lights in a Vicon Markerless system, see see Getting started with your Vicon Markerless system and Getting started with Vicon Shogun Markerless , both available from the Vicon website .


Note

Important
The light source (LEDs) of this illuminator IR light is not replaceable. When the unit reaches its end of life, please dispose of the whole illuminator IR light and re-cycle where possible.

...