Manage sensor names
- Felix Tsui (Unlicensed)
- Gisela Roberts
In Capture.U 1.4.1 or later, you can assign a name to each sensor to help identify the sensor (eg, by placement or landmark).
To assign a name to a sensor, enter any capture mode (see Start Capture.U and choose a collection mode).
When you're prompted to select a sensor, swipe left on any sensor and select Edit Name.
In the following example, Real-Time Insight mode is used to assign sensor names. The ability to assign sensor names in the other modes is covered in each mode's workflow, found from Start Capture.U and choose a collection mode.
From the home screen, select Real-Time Insight.
At the bottom of the screen, tap Select Sensors.
In the list of sensors, swipe left on the sensor you wish to assign a name to.
To the right of the line that contains the sensor name, tap Edit Name.
Enter a name and press Return on the keyboard.
The sensor is displayed as Serial # (Sensor Name) on this screen and any others in which the sensor is identified.
- Repeat as needed.
Note
Sensor names are saved to the iOS device and are retained across sessions.
It follows that a specific sensor (identified by serial number) may have a different sensor name on a different iOS device.
