/
Modeling with Plug-in Gait

Modeling with Plug-in Gait

Owned by Gisela Roberts
Last updated: Dec 16, 2024

Vicon Nexus provides you with the following options for modeling:

Plug-in Gait and the Oxford Foot Model

If you are new to modeling with Nexus, the Plug-in Gait model provides a good introduction: all the operations necessary to run the model are supplied with Nexus. This option is described in this guide. For details, see:


In addition, a Vicon Nexus 2 tutorial video, PlugIn Gait AI: Marker Locations and Subject Measurements, is available on YouTube.

Note
As the videos were recorded using an earlier version of Nexus 2, you may notice small differences in the user interface.

MATLAB

If you are familiar with MATLAB, you can use the supplied examples to create your own custom models. For more information, see Modeling with MATLAB in the Vicon Nexus Reference Guide.

Python

If you are familiar with Python, you can use the supplied examples to create your own custom models. For more information, see Modeling with Python in the Vicon Nexus Reference Guide.

Note
For simplicity, modeling operations are described as separate steps. However, if you want to run modeling operations automatically, you can add them (and any other operations required) to a post-capture pipeline that runs as soon as capture finishes. For more information see step 7 in Capture the required movement.

Related content

© Copyright Vicon Motion Systems. All rights reserved.

Vicon trademarks